What you will learn in this Session

During this session you will learn how to :

• Use Layer control to create a new layer for the Model.
• Prepare the sketch for 3D Solid creation.
• Extrude a profile to create a solid.
• Blend the edges of a solid.

Introducing

The following tools will be used during this Session :

• Layer control.
• Extrude Solid.
• Blend Edge.

information about this session

• The 3D model in this Session is produced from the 2D sketch geometry created in the 2D Tutorial of this Session. If you have not produced the sketch or retained a copy, use the sample drawing for this Session.
• Should you wish to retain two separate drawings for the Sketch and Model, save the Sketch drawing to another name.
• Some views in the illustrations may be rotated for illustrative clarity. Should you wish to rotate view to reflect the view shown in the illustrations, use View > Rotate View.
• The sample drawing for this session contains the 2D Sketch and the 3D Model. Frequently, these 2 layers are superimposed. Use the TurboCAD Explorer to control the display of the layers. Create your own layers if you wish to produce the design from scratch or pan to an unused area of the editor.
• Downloadable Session Drawings can be found here

Estimated Session Duration

• Approximately 30 minutes drawing time. Total session duration may vary.