What you will learn in this Session

During this session :

• The initial sketch geometry for the sketch will be produced.
• Lines will be drawn tangentially to circles.
• Lines will be drawn to a specific length and angle.
• Arcs will be offset to create parallel curves.
• The sketch will be trimmed and fillet radii added.
• A polar duplicate will be created of an inner circle.

Introducing

The following tools will be used during this Session :

• Line at angle.
• Tangent Lines
• Offset Curve.

Information about this Session

• The sketch geometry created in this Session will be used to build the model in the 3D Tutorial of this Session. Save your design at the end of the Session.
• Should you wish to retain the sketch in order to produce the engineering drawing, save a copy of the 2D sketch to a separate drawing name.
• The sample drawing for this session contains the 2D Sketch and the 3D Model. Frequently, these 2 layers are superimposed. Use the TurboCAD Explorer to control the display of the layers. Create your own layers if you wish to produce the design from scratch or pan to an unused area of the editor.
• Downloadable Session Drawings can be found here

Estimated Session Duration

• Approximately 45 minutes drawing time. Total session duration may vary.